Where the Company Started
Machining began here in 1997, starting with a heat treatment family workshop in Huzhou, Zhejiang. The company was officially registered in January 2011. In 2017, Sany Heavy Industry began working with the company to source crane boom joints. Third-party audits followed, along with recognition as a "Quality Supplier." By 2022, the company had become a main supplier of this type of joint.
That experience also goes into the Transmission End Cover. It is a key sealing and support component inside a gearbox assembly. HT250, QT450-10, or ADC12 aluminum alloy is used for production. High-strength cast iron or alloy material is precision machined to maintain a flat end face and accurate bearing and oil seal seats. The Transmission End Cover seals the housing, positions the bearings, and limits axial movement.

Sealing That Holds
A gearbox end cover must maintain a reliable seal under operating conditions. This design resists shock and impact while keeping the sealing area tight and limiting deformation during operation. The working temperature ranges from -40°C to 150°C. End face flatness is maintained at ≤0.03 mm, bearing hole accuracy reaches IT7, and hole position tolerance is ≤0.05 mm. Surface roughness reaches Ra≤1.6 μm.
The sealing structure uses an O-ring groove or oil seal mounting seat, with bolt fixing for installation. Applicable speed reaches up to 8000 r/min. The part is suitable for car, light truck, and heavy truck gearbox assemblies, including both manual and automatic transmissions. It is designed for applications involving high speed, temperature changes, and complex road conditions. Custom machining based on vehicle model and specifications is available.

Payment, Warranty, and What Buyers Ask
Payment terms are flexible. Regular orders use 30% prepayment, 50% before shipment, and a 20% balance. Custom products use 50% prepayment, 30% before shipment, and a 20% balance. RMB, USD, and other currencies are accepted. EXW, FOB, and DDP trade terms are supported.
Bulk orders are eligible for discounts, and the goods are covered by a warranty. Goods damaged upon arrival can be returned free of charge. Buyers ordering the Transmission End Cover usually ask about bearing hole accuracy first, because poor dimensional control can lead to shaft runout and operating noise.

Key Parameters
|
Parameter |
Value |
|
Material |
HT250 / QT450-10 / ADC12 aluminum alloy |
|
Working temperature |
-40°C to 150°C |
|
End face flatness |
≤0.03 mm |
|
Bearing hole accuracy |
IT7 |
|
Surface roughness |
Ra≤1.6 μm |
|
Applicable speed |
≤8000 r/min |
Hot Tags: transmission end cover, China transmission end cover manufacturers, suppliers, factory, custom flange automotive parts, custom pump automotive parts, custom support automotive parts, precision cooling automotive components, precision pin automotive components, precision powertrain components













